FAQs - IBC's

As a leading storage tank supplier, Fuel Tank Shop receives enquiries about safe, secure and environmentally responsible fuel storage. To find answers to some of the most Frequently Asked Questions... just click the relevant category to your need. If however, you have a question we haven't answered then please do not hesitate to contact us for further assistance

IMPORTANT INFORMATION: Every effort is made to keep this area of the site up to date. However, Fuel Tank Shop cannot be held liable for errors or omissions. Compliance with statutory requirements is the responsibility of the person(s) who install, use and maintain products supplied by Fuel Tank Shop. If you have concerns over compliance, you must seek professional advice, contact your local Building Control Officer, your local environmental authority or OFTEC. Fuel Tank Shop strongly advises that all oil storage installations should be installed and maintained only by an OFTEC Registered Technician. Fuel Tank Shop will not be responsible for installations which do not comply with prevailing statutory requirements.

IBC's

How do I safely fill an IBC?

To safely fill an IBC first make sure that the pallet, cage and bottle and valve are suitable for use with the intended product. Ensure that the valve is securely tighten to the inner bottle and that the valve is closed and that the drip cap is secured and tightened. Check that the inside of the bottle is clean. When hot filling product do not exceed 65°C. When bottom filling make sure that the vents are functioning correctly or open the top cap. Do not over fill the IBC. After filling, if the product has a UN number, ensure that the lid seal is correctly positioned and tighten the screw cap to 70-80 Newton/Meters.

How do I transport an IBC safely?

Do not lift IBCs from the top frame. Ensure that the fork truck tines are fully inserted under the IBC before lifting. Ensure that the vehicle floor is in good condition and free of all nails etc. that could puncture the IBC. Always transport IBCs with the correct labelling attached to the ID Plate.

Always secure IBCs to prevent possible movement during transit.

Can the IBC's (intermediate bulk containers) be stacked?

Yes, depending on the pallet type, our IBCs can be stacked as follows whether empty or full:

MX IBCs - with metal or plastic pallets - Up to 4 High (with a maximum SG of 1.6)

SX IBCs - with metal pallets - Up to 4 High (with a maximum SG of 1.6)

LX IBCs - with wooden or plastic pallets - Up to 3 High (with a maximum SG of 1.4)