Replacement Filter for Bottom Outlet Kit (2 Outlets) or Tankmaster Sight Gauge

Product Ref: TM4660F

Approx 3-5 Days

Home Delivery

United Kingdom mainland delivery from £9.95 ex VAT

Parcel Delivery (Highlands & Islands are charged at a higher fee than standard)

check delivery cost

Replacement Filter for Bottom Outlet Kit (2 Outlets) or Tankmaster Sight Gauge Description

Replacement Filter for Bottom Outlet Kit - 2 Outlets

Including:

  • Filter
  • 'O' Ring
  • Washers
  • Bolt

Used to trap and remove contaminants from air, gas, or fluid streams in various industrial and commercial systems. It helps maintain clean and efficient operation by preventing debris from entering sensitive components, thereby ensuring smooth functioning, reducing wear, and prolonging the lifespan of equipment.

This kit is designed for the Mark II Tankmaster; however, if a filter replacement kit is required for a Tankmaster Mark I then you can use this kit by placing a small (2″) cable tie around the tube immediately below the filter to hold this up against the body of the Tankmaster.

Cleaning the filter element to reuse it is not recommended. The cleaning fluid can leave a film over the surfaces of the nylon element, which effectively reduces the size of the holes in the mesh.  Although the filter will look clean, the reduction in the size of the holes in the mesh will act in the same way as if the filter was still dirty/clogged.

The ‘O’ ring supplied for going around the bolt at the bottom of the filter housing is tapered on one edge and must be fitted with this tapered edge facing uppermost (i.e. facing towards the filter bowl).  This usually compresses into a flat shape so that when this is removed again for servicing the service engineer thinks that he requires a flat washer and has been supplied the wrong part (this is not the case)

 

People who bought this also bought...